What the spare parts uses constantly is machine to take cutter track line on numerical control lathe
Time:
Click:74
source:ASEM CNC Machining
What the spare parts uses constantly machine to take cutter track line on numerical control lathe: (1) when the course taking a knife of car circular arc analyses practical car circular arc, need much knife treatment, excise major surplus first, final ability car goes place to need circular arc. The treatment line with car commonly used circular arc introduces below. Graph a flight of stairs of the 1 circular arc that it is a car takes cutter track line. Graph 1 graph 2 (A) the homocentric circular arc of the circular arc that it is a car takes cutter track line. Graph 2 graphs the course of cutting of car awl law of the 3 circular arc that it is a car namely first car conic, again car circular arc. Graph 3 (2) the 4 of graph of analysis of course taking a knife with conic car (3) the analytic graph 5 that feed of the axial when car whorl is apart from (4) the course taking a knife of grooving analyses turning precision not tall and width is narrower, usable Dao Kuan is equal to the recessing knife with wide chamfer, use car of the straight primary feed that take a way to go out. The groove with precision higher demand, use feed car 2 times to become commonly, namely when recessing of first time feed, two side leave groovy wall fine vehicle surplus, use the 2nd times when feed wait for wide knife nap. The groove with wider car, can adopt the straight cut that take a way for many times, leave finish machining surplus in groovy wall and underside, vehicle of last knife fine comes dimension. If pursue,6 are shown. Graph 6 CNC Milling